Analog Devices Inc. ADG719BRMZ

The electronic component is convenient to ship overseas because it is packed in a 8-TSSOP, 8-MSOP (0.118, 3.00mm Width). In order to provide high reliability, an advanced packaging method Tube is used. There is an analog multiplexer mounted in position Surface Mount. Multiplexers and demultiplexers have a ratio of 2:1. Around -40°C~125°C TA is the extended operating temperature. In total, there have been 8 terminations.

The electronic part delivers high-quality output through its 1 channels. If the voltage supply is 3V volts, the electrical component should be turned on and run. There is an electrical component included in the 8 series. SPDT switching circuits are used in these analog switch ics. Use ADG719 to search for variants of the digital switches. A 4Ohm internal resistance characterizes this multiplexer.

Datasheets for functions of 8 pins are available. This switch device is a typical Multiplexer or Switches. Multiplexers should not be powered above 5.5V in normal situations. In order for the electronic part to function properly, the lowest voltage should be 1.8V. An operating current of 1nA would be sufficient for this switch device.

This analogue multiplexer requires a voltage of 1.8V~5.5V when it drains from a single voltage supply. It may damage the digital multiplexer if the voltage is higher than 1μA. In 200MHz-bandwidths, data can be transferred. There is 2.5Ohm Drain to Source resistance on this electronic part. The analog switch ics has 2 outputs.