Fire Alarm Gas Extinguish Security Control Panel CM-1004 – Best Price for Trade

The controller is connected with Conventional Smoke Detector, heat Detector, Manual call point, on-site emergency start/stop button, aerosol extinguishing control device (or cylinder control device), weighing device, exhaust indicator light and other equipment. Constitute a complete automatic fire alarm and fire fighting system. Download manual and diagram for fire alarm and fire fighting system.
Conventional Fire Fighting Panel

Key Specifications/Special Features

• Four Style B（Class B）Initiating Device Circuits（IDCs）。
  
• All zones accept two-wire smoke detectors and any normally-open contact devices.
  
• One built-in Fire Fighting Ouput.
  
• 24-volt operation.
  
• Resettable four-wire smoke detector power＠500 mA.
  
• Non-resettable power＠500 mA.
  
• One-man walk-test programmable for silent or audible test.
  
• Disable/Enable control per IDC.
• Reverse polarity protection

There are 6 buttons on the panel, Emergency evacuation, external muffler, Self-test/Reset, Internal muffler, exhaust fan, Emergency Stop

Control lock allows and disables key function, manual and automatic switching modes

The standby 12V/4.5A power supply is placed at the bottom of the chassis. If the battery polarity is incorrect, the yellow battery fault message is displayed on the panel.

Emergency gas release: Pull out the yellow plastic box panel on the panel, and there is a red button inside. Press the button, the controller will enter the "emergency start" delay state, showing a countdown of 10 seconds, and send a start signal after the countdown is over.

L Controller has 4 independent alarm area (ZONE1-ZONE4), can be connected with multi-line smoke, temperature, manual alarm
Button and other input equipment, can independently complete equipment fault detection and alarm function.
L The controller has three sound and light alarm outputs (SounD1-SOUND3), which can be easily used for external emergency alarm in case of fire
L the controller has one 24VDC/1A POWER output (power-24 v,0V) to supply POWER to external devices.
L Controller has 1 way fault, 1 way fire alarm relay output.
L The controller has remote mute, remote alarm test, remote fault test and remote reset functions.
L The controller has remote emergency start, remote emergency stop and remote hand/automatic mode switching functions.
L The controller has cylinder pressure undervoltage signal receiving function and gas release feedback signal receiving function.
L The controller has valve function.
L The controller can set 0-75s delay valve function.
L The controller has the function of manually opening and closing the exhaust fan.
L The controller has RS485 interface, which can transmit alarm information with the upper computer or the floor repeat display.

Vedard Security Alarm Technology, a wholesaler and exporter from China, provides this panel at competitive prices, delivering cost-effective solutions for buyers in the fire safety industry.